27
Where the numeric values are:
Channel number. Channel 2 refers to a trigger
output.
MD
Mode: 1 = pulse, 2 = switched.
S
Brightness setting as a percentage.
DL
Pulse delay.
PU
Pulse width.
RT
Retrigger delay.
IP FL
CS RA
These values are unused.
ST0
Reports the general settings. Typical output is:
TM 1, TP 20.00ms
Where:
TM
= Internal trigger: 0 = off, 1 = on
TP
= Internal trigger period
STc
Reports settings for a single channel.
c
=
1
to select light strobe output
c
=
2
to select a trigger output signal
Simulate an Input Trigger
TR1
Simulates a trigger pulse. If the channel is in pulse mode it emits a single
pulse.
Enable Ethernet Messages
GTm
Where:
m
=
0
to disable Ethernet messages
m
=
1
to enable Ethernet messages
When Ethernet messages are enabled, any error reports are sent to the
most recent UDP or TCP address from which a command has been
received.
Messages are of the form:
Evt1,e
Where:
e
= event value: 32 to 47 are lighting error codes.
CH
Содержание PULSESTAR VTR6
Страница 1: ...PULSESTAR VTR6 Installation Guide Issue 005...
Страница 2: ...For your notes...
Страница 36: ...32...
