Raytec PULSESTAR VCT6 Series, Руководство по установке

Страница: 34 / 41

33
For example:
Parameter Meaning
0.1 0.1 milliseconds
200us 200 microseconds
0.1s 0.1 seconds
Note: The characters are in USA/UK format, so that ‘a half’ is written as ‘0.5’
(rather than ‘0,5’).
The command codes and their meanings are summarised below (that is, in the
table on the next page). The upper-case commands are shown, followed by
lower case letters denoting the numeric argument.
Note: Any changes made using Ethernet commands are not saved permanently until
the AW command has been issued.
10.2
General commands
The general command codes and their meanings are described below. The
upper-case commands are shown, followed by lower case letters denoting
the numeric argument.
Note that any changes using these commands are not saved permanently until
the
AW command has been issued.
Save the settings to memory
AW
Once the settings are saved to memory, they are retained when the unit
is switched off. If this is not done, changes to the settings are volatile,
and if the unit is switched off, they revert to those in force when the last
AW command was issued.
Report the firmware version
VR
This command returns the firmware version currently running in your
VCT6. For example:
VCT6 (HW002) V007