5. AT Command
5.1. List of supported commands
-
Setting of scanned device name
-
Setting of scanned base UUID/service UUID/TX character/RX character
-
Setting of scanned RSSI threshold
-
Choose data rate of 1M bps or 2M bps on-air
-
Set TX output power in 5 levels.
-
Set scanning time
-
Enable/disable scanning
-
Set LED pattern indicating scanning or connecting status
-
7 sets of UART baud rates
-
Enable/disable UART flow control
-
Power-down mode for power saving and GPIO wake-up
-
Support DC-to-DC and LDO power mode
-
Use internal or external 32.768KHz oscillator
-
Recover-to-default setting with hardware and software method
-
System reset of hardware and software
-
Set serial number and retrieve
-
Retrieve MAC Address
-
Retrieve ADC value for battery detection
-
Support maximum MTU 247bytes / data payload up to maximum 244 bytes
-
Enable/Disable Beacon information printed out through UART interface
(31 bytes beacon)
-
Support scan Beacon company ID/UUID (31 bytes beacon)
Содержание MDBT42Q-AT-UART-M
Страница 6: ...3 Reference Circuit...