6. Brightness control
Adjust overall brightness. Press to increase
brightness and press to decrease. The color
temperature will keep unchanged when adjust brightness.
The controller applies brightness gamma correction on
dimming control, makes the brightness tuning more
smooth to human sense.
7. Color temperature control
Adjust LED color temperature. Press to increase
the color temperature and press to decrease. The
overall brightness will keep unchanged when adjusting
color temperature.
9. Color temprature shortcut keys
Set the color temperature to full cool white, full
warm white or neutral white which is 50% warm and
50% cool white.
10. Remote indicator
This indicator blinks when remote controller is
working. If the indicator flash slowly when pressing keys,
it means the remote battery is nearly empty and please
change the battery in this case. The battery model is
CR2032.
8. Brightness shortcut keys
Jump to the relative brightness level when press the
corresponding keys.
11. Using the remote controller
Please pull out the battery insulate tape before
using. The RF wireless remote signal can pass through
some nonmetal barrier. For proper receiving remote
signal, please do not install the controller in closed
metal parts.
12. Pair a new remote controller
The remote controller and main unit is 1 to 1 paired as
factory default. It’s possible to pair maximum 5 remote
controllers to one main unit and each remote controller
could be paired to any main unit.
13. Keep current remote only
In some cases, one main unit might be paired with
several remote controllers but extra remote controllers are
no longer needed. User could simply pair the current
using remote to main unit again, then the main unit will
dis-pair all other remote controllers and recognize current
one only.
User could pair a new remote controller to main unit
by following two steps:
1). Plug off the power of main unit and plug in again
after more than 5 seconds.
2). Press and key simultaneously for about 3
seconds, within time of 10 seconds after the main unit
powered on.
Advanced features
14. Waterproof (-S version)
The IP-68 waterproof feature with glue injection
finish is available on -S version controllers. For overall
waterproof performance, the cables must be waterproof
treated separately.
Wireless signal degrade
: The wireless communication
ability could degrade when using at wet environment,
please be aware that the wireless control distance will be
shortened in such case.
15. Protection function
The controller has full protection function against
wrong wiring, load short circuit, overload and overheat.
The controller will stop working and the indicator will
flash with red / yellow color to indicate the malfunction.
The controller will try to recover from protection status
in a short time when the working condition is good.
For protection issues, please check the situation
with different indicator information:
Red flash:
Check the output cables and load, make
sure no short circuit and the load current is in rated
range. Also the load must be constant voltage type.
Yellow flash:
Check the installation environment,
make sure in a rated temperature range and with good
ventilation or heat dissipation condition.
Model
P20
P20-S
Brightness grade
7 levels
Color temperature grade
7 levels
Color temp. shortcut
3 shortcuts
Brightness shortcut
3 shortcuts
PWM grade
4000 steps
Overload protection
Yes
Overheat protection
Yes
Working voltage
DC 5-24V
Remote frequency
433.92MHz
Remote control distance
>
15m at open area
Rated output current
2x7A
IP Grade
IP63
IP68
Specification
Operation
