Model
NT30(W/Z/B)
Output Mode
PWM constant voltage
Working voltage
DC 12-24V
Rated output current
3x4A
Tuya connection
W: Wifi; Z: Zigbee; B: Bluetooth
Remote frequency
433.92MHz
Remote control distance
>
15m at open area
PWM grade
4000 steps
Overload protection
Yes
Overheat protection
Yes
Controller dimension
87x24x15mm
Remote dimension
86.5x36x8mm
10. Remote indicator
11. Using the remote controller
Please pull out the battery insulate tape before using.
The RF wireless remote signal can pass through some
nonmetal barrier. For proper receiving remote signal,
please do not install the controller in closed metal parts.
This indicator blinks when remote controller is
working. If the indicator flash slowly when pressing keys, it
means the remote battery is nearly empty and please
change the remote battery (CR2032 type).
Operation
13. Pair a new remote controller
Specification
14. Reset to factory default
8. Brightness control
Press key to increase RGB LED brightness and
press key to decrease.
9. RGB dynamic effect
These keys control the RGB dynamic effects. Press
and to select dynamic effects and press and
key to set the running speed of the dynamic effects.
Press the key to activate the dynamic demo
mode, the controller will play dynamic effects in loop
with repeating for 3 times for each effect.
EFFECT
EFFECT
12. Setup Tuya connection
Please install the Tuya app to setup the smart
connection. Before setup, please make sure the controller
is at factory default mode and not connected to other
gateway or router. The controller indicator should be yellow
color at this status.
4
5
6
6/7. Static RGB color setting
The keys in this area set the RGB static color. Press the
colored keys to set the RGB LEDs to correspond color as
shortcut. Press and key to select color from the
preset library colors.
The remote controller and receiver is 1 to 1 paired as
factory default. It’s possible to pair maximum 5 remote
controllers to one receiver and each remote controller
could be paired to any receivers.
To pair a new remote controller, please follow two
steps:
1). Plug off the power of receiver and plug in again
after more than 5 seconds.
2). Press and key simultaneously for about 3
seconds, within 10 seconds after the receiver powered
on.
After this operation, the indicator will flash 3 times
to acknowledge that remote pairing is accomplished.
To reset the controller’s Tuya setting and unpair all
remote controllers, please operate with following two
steps:
1). Plug off the power of controller and plug in again
after more than 5 seconds.
2). Press and key simultaneously for about 3
seconds, within 10 seconds after the receiver powered
on.
After this operation, the indicator will flash yellow
color for 3 times and the controller will be reset to
factory default, the Tuya connection and remote pairing
will all be reset.
The controller has full protection function against
wrong wiring, load short circuit, overload and overheat.
The controller will stop working and the indicator will
flash with red / yellow color to indicate the malfunction.
The controller will try to recover from protection status
in a short time when the working condition is good.
For protection issues, please check the situation
with different indicator information:
Red flash:
Check the output cables and load, make
sure no short circuit and the load current is in rated
range. Also the load must be constant voltage type.
Yellow flash:
Check the installation environment,
make sure in a rated temperature range and with good
ventilation or heat dissipation condition.
Protection Function
