Raymarine ST60 Tridata, Руководство по вводу в эксплуатацию

Страница: 15 / 24

7
Chapter 2: Preparation for Use
2.1 Introduction
Use this chapter to set up and check the ST60 Graphic Display, before it is
used operationally. Instructions are given to enable you to:
• Define the function of the
NMEA OUT
connector (see Chapter 1, System
Connections ).
• Carry out Dealer calibration.
• Check basic operation.
EMC conformance
Always check the installation before going to sea to make sure that it is not
affected by radio transmissions, engine starting etc.
2.2 Initial setup
Defining the NMEA OUT connector function
The
NMEA OUT
connector can be used to either:
• Output supported NMEA data to an external NMEA system.
or
• Output alarm signals to an Auxiliary Alarm.
If a connection is made to the
NMEA OUT
connector, use the following
procedure to define the function:
1. Hold down the and buttons for approximately 2 seconds so that
the User calibration entry screen is displayed.
Note: The User calibration entry screen will time out to the main display
after 7 seconds, if you do not proceed.
2. Press the button to enter User calibration.
3. Use the button to cycle to the NMEA on/off screen.
4. Use the
track
or
reset
button to switch the
NMEA OUT
function
ON
or
OFF
, as required. If you set:
•
NMEA ON
, then the Auxiliary Alarm output is disabled and the next
screen shows
ALARM DRIVE UNAVAILABLE
.
•
NMEA OFF
, then the Auxiliary Alarm output is available and you can
switch the Auxiliary Alarm drive
ON
or
OFF
at the next screen, using
the
track
or
reset
buttons.
81228_1.book Page 7 Wednesday, November 19, 2003 10:29 AM