,
4
Depth Operation and Installation Handbook
1
Cable boss 2 Fiiing studs
nuts
1.2 Mounting Procedure
1. Make
that the selected location is
clean,
smooth and flat.
2. Apply the self-adhesive template (supplied) to the selected location and
mark the centres for the
studs and the cable boss
3. Drii two 4mm
clearance holes for the
studs through
the bulkhead. Remove the template.
4. Cut the clearance hole for the cable boss using a 50mm
diameter cutter.
5. Screw the two fixing studs into
control head.
6. Pass the
cable and transducer tails through the cable-boss
clearance hole.
7. Assemble the
head to
bulkhead and secure from behind
using the thumb nuts
Note:
The rear case is fitted with a foam gasket to form a water-tight seal between
the instrument and the selected installation face. Under no circumstances
must silicone greases be applied to this gasket as an additional
of
sealing-the silicone will expand and distort the
rear case.
1: Control Head Installation
Bracket Mounting
The ST50 Plus Depth can, as an alternative, be bracket mounted using the
Mounting Kit.
Flush Mounting
A flush mounting kii is available for installations where a flush mount is
required or more desirable. Full installation instructions are provided with
the kit.