Plus Depth Operation and
Handbook
Chapter 4: Operation
Certain atmospheric conditions may cause condensation to
on the
control head window.
will not harm the unit and can be cleared by
increasing the illumination setting to Level 3.
Chemical and
materials must not be used to clean the control head;
if it is dirty, clean with a soft, damp cloth.
Transducer
Refer to the Installation and Maintenance instructionssupplied with the
transducer.
Cabling
Examine all cables for chafing or damage to the outer shield and, where
necessary, replace and resecure.
For
or further information regarding the
of
product,
please contact the
product Support Department or your own
National Distributor.
As it leaves the factory the ST50 Plus Depth is set with:
‘depth units in feet
transducer off set set to 0 feet
shallow alarm set to 10 feet
deep alarm set to 100 feet
low anchor alarm set to 50 feet
high anchor alarm set to 50 feet
These settings can be changed in calibration, Chapter 6.
When the
is poweredup for the first time water depth will be displayed.
Note:
that the display ‘is not being updated and that
currently
was the last valid echo.