Raymarine Remote Keypad, Руководство пользователя

Страница: 14 / 28

8 SeaTalk Remote Keypad Owner’s Handbook
• If a suppression ferrite is attached to a cable, this ferrite should not
be removed. If the ferrite has to be removed during installation it
must be reassembled in the same position.
Suppression Ferrites
The following illustration shows the typical range of suppression
ferrites fitted to Raymarine equipment. Always use the ferrites
specified by Raymarine.
Connections to other equipment
If your Raymarine equipment is going to be connected to other
equipment using a cable not supplied by Raymarine, a suppression
ferrite MUST always be fitted to the cable close to the Raymarine unit.
Tools
• 5 mm twist drill • 45 mm (1.77 in) tank cutter/hole saw
• Power drill • Screwdrivers
Site requirements
The SeaTalk Remote Keypad must be installed:
• In a flat, smooth location.
• At least 230 mm (9 in) away from your vessel’s steering compass
and 500 mm (20 in) from radio equipment.
• So there is sufficient space behind the facia to accommodate the
cables, fixing studs and thumb nuts.
If you intend siting the keypad next to an instrument or another
keypad, make sure that they are separated by at least 3 mm to enable
sun covers to be fitted, when required.
073_5txt.p65 1/22/2003, 10:07 AM 8