Raymarine RAY50, Монтаж и начало работы

Страница: 7 / 26

Note: Where constraints on the installation
prevent any of the above recommendations
,
always ensure the maximum possible separation
between different items of electrical equipment, to
provide the best conditions for EMC performance
throughout the installation
Antenna mounting and EME exposure
Ensure that the antenna is connected to the radio
before transmission.
Raymarine declares a Maximum Permissible Exposure
(MPE) radius of 1.5 metres (4.9 ft) (per OET Bulletin
65) for this system, assuming 25 watts output to an
omnidirectional antenna of 3dBi gain or less.
For watercraft with suitable structures, the antenna
base must be at least 3.5 metres (11.5 ft) above the
main deck to meet the MPE for persons up to 2 metres
(6.6 ft) tall. For watercraft without such structures, the
antenna must be mounted so that its base is a minimum
of 1.5 metres (4.9 ft) vertically from heads of all persons.
The antenna must be isolated from the vessel’s
metalwork using an insulated (e.g. plastic) mounting
bracket.
Connections to other equipment
Requirement for ferrites on non-Raymarine cables
If your Raymarine equipment is to be connected to other
equipment using a cable not supplied by Raymarine, a
suppression ferrite MUST always be attached to the
cable near the Raymarine unit.
Declaration of conformity
Raymarine UK Ltd. declares that this product is
compliant with the essential requirements of R&TTE
directive 1999/5/EC.
The original Declaration of Conformity certificate
may be viewed on the relevant product page at
www.raymarine.com .
Product disposal
Dispose of this product in accordance with the WEEE
Directive.
The Waste Electrical and Electronic Equipment
(WEEE) Directive requires the recycling of waste
electrical and electronic equipment.
Warranty registration
To register your Raymarine product ownership, please
visit
www.raymarine.com and register online.
It is important that you register your product to receive
full warranty benefits. Your unit package includes a
bar code label indicating the serial number of the unit.
You will need this serial number when registering your
product online. You should retain the label for future
reference.
IMO and SOLAS
The equipment described within this document is
intended for use on leisure marine boats and workboats
NOT covered by International Maritime Organization
(IMO) and Safety of Life at Sea (SOLAS) Carriage
Regulations.
Technical accuracy
To the best of our knowledge, the information in this
document was correct at the time it was produced.
However, Raymarine cannot accept liability for any
inaccuracies or omissions it may contain. In addition,
our policy of continuous product improvement may
change specifications without notice. As a result,
Raymarine cannot accept liability for any differences
between the product and this document. Please
check the Raymarine website (
www.raymarine.com ) to
ensure you have the most up-to-date version(s) of the
documentation for your product.
Applicable products
This document is applicable to the following products:
Name
Part
number
Features
E70243 Ray50 • SeaTalk ng® /
NMEA 2000
• NMEA 0183
• Passive
speaker
connection
E70345 Ray52 • SeaTalk ng® /
NMEA 2000
• NMEA 0183
• Built-in GNSS
(GPS and
GLONASS)
receiver
• Passive
speaker
connection
7