Raymarine i50 Depth, Инструкция по установке и эксплуатации

Страница: 27 / 90

4.5 iTC-5 connection
Transducers can be connected to a SeaTalk ng
network using Raymarine's Instrument transducer
converter (iTC-5) and an i70 instrument, the data
can then be repeated on an i50 / i60 unit.
12 V
D12033-3
1 2 3 4
5
6 7 8
1 i50 Depth (Repeater)
2 i70 Instrument (Master)
3 i50 Speed (Repeater)
4 i60 Wind (Repeater)
5 iTC-5
6 Depth transducer
7 Wind vane transducer
8 Speed transducer
Note: Transducers connected to the iTC-5 must be
calibrated using an i70 (master) unit. Transducers
connected to the iTC-5 cannot be calibrated using
an i50 / i60.
Making iTC-5 transducer connections
For instructions on connecting transducers to your
iTC-5 refer to the iTC-5 handbook.
4.6 SeaTalk connection
Connections to an existing SeaTalk system must be
made using a SeaTalk to SeaTalk
ng adaptor cable.
Basic SeaTalk system example
12 V dc
12 / 24 V dc
D12058-2
9 8
1 1 1 2
4 1 2 3
7
5
6 6 7
1 0
1 i70 Instrument display
(SeaTalk
ng )
2 i50 Speed instrument
(SeaTalk
ng )
3 i50 Depth instrument
(SeaTalk
ng )
4 Raymarine wind vane
transducer
5 i60 Wind instrument
(SeaTalk
ng )
6 SeaTalk ng cables
7 SeaTalk to SeaTalk ng adaptor
cables
8 Speed transducer
9 Depth transducer
10 12 / 24 V dc power supply
11 SeaTalk Course computer
(providing 12 V dc power to
SeaTalk network.)
12 ST6002 pilot controller
(SeaTalk)
SeaTalk power protection
The power supply must be protected by a 5 A fuse
or a circuit breaker providing equivalent protection.
Raymarine recommends that the power is connected
to a SeaTalk system in such a way that the current
drawn on each side of the power connection point
is equal.
Cables and connections 27