Raymarine Evolution EV-1, Руководство по установке

Страница: 110 / 142

Alarm Message Possible causes Solution
NO DATA • The autopilot is in Wind
Vane mode and has not
received wind angle data for
32 seconds.
• The autopilot is in Track
mode and is not receiving
navigation data, or the rudder
angle sensor is receiving a
low-strength signal. This
will clear when the signal
improves.
Check the connections to the
wind transducer, multifunction
display, and autopilot control
head (as appropriate).
PILOT STARTUP Autopilot components are
initializing. Some components may take a
moment to startup.
NO WIND DATA The autopilot is in Wind Vane
mode and has not received
wind angle data for 32 seconds. Check the connections to the
wind transducer.
NO SPEED DATA
The autopilot has not received
speed (STW or SOG) data for 10
seconds, while in Auto mode.
Check the connections to
the speed transducer. Pilot
does not require speed data
in order to operate. However,
it does enhance the overall
performance when in Auto
mode.
NO COMPASS The EV-1 or EV-2 is not
receiving heading data. • Check the connections to the
EV-1 / EV-2.
• Power cycle the EV-1 /
EV-2, by removing and then
reconnecting the SeaTalkng ®
cable.
RATEGYRO FAIL
The internal rate gyro on the
EV-1 or EV-2 unit has developed
a fault. This will be evident
as a compass issue and could
cause the compass heading to
deviate or lock-up.
If the problem persists, contact
your local Raymarine service
center.
MOTOR POWER SWAPPED On the Evolution ACU unit, the
motor cables are connected to
the power terminals, and vice
versa. Switch off the power to the unit
and reconnect correctly.
NO GPS DATA A source of GPS data is not
connected to the SeaTalkng ®
system. Check connections to the GPS
data source.
JOYSTICK FAULT A fault has occurred with the
joystick. This alarm applies
only to autopilot systems that
include a joystick controller. Check the connections to, and
operation of the joystick.
NO IPS (NO DRIVE DETECTED) Loss of communications
between the EV-1 and ACU, or
EV-2 and drive interface unit. Check all physical data
connections between these
devices, as appropriate.
110