Raymarine E12207, Руководство по установке

Страница: 27 / 42

3.6 Reservoir mounting
The reservoir must be mounted on a bulkhead as far above the
pump and hydraulic ram as possible.
• Before mounting the reservoir, refer to the guidance provided in
the 2.8 Location and mounting requirements section.
• Secure the reservoir to the appropriate part of your vessel, using
the mounting holes provided. Use suitable stainless steel bolts,
washers and lock nuts.
3.7 Filling the reservoir
The hydraulic fluid reservoir is supplied empty and must be filled to
the correct level with the supplied hydraulic fluid.
Do NOT attempt to move or operate the hydraulic push rod before
completing the following steps:
1. The reservoir is fitted with a special cap featuring a breather
hole, which is sealed for transit purposes. Remove the transit
screw and seal from the cap to open the breather. Retain the
screw and seal for future use.
2. Fill the reservoir with the supplied hydraulic fluid to a level
between the minimum and maximum indicator lines.
3. Turn the tap to the “ON” position (tap should be pointing upward).
Mounting
27