Raymarine CP100, Руководство по установке

Страница: 30 / 48

6.1 Initial power on test
Once the unit has been correctly installed check that it is
operating correctly.
After powering on, the unit will take approximately 50 seconds
to bootup, from powering on through to normal operation LED
status indicator should be GREEN. If the LED status indicator
is not green then refer to the troubleshooting section of this
handbook.
Open the Fishfinder application on your connected multifunction
display and ensure that it is operating correctly.
Further information
For detailed operating instructions, refer to the handbook that
accompanies your multifunction display.
Multiple sonar operation
For systems with multiple sonar modules, only one sonar may
operate at any one time.
Before attempting to use the fishfinder application on your
multifunction display, use one of the methods described in this
document to ensure that only one sonar module is active on
your system.
Switching between internal and external sonar modules
If you want to switch your active sonar module between internal
and external follow the steps below.
1. Power off the active sonar module.
• Internal sonar module is turned off from the Fishfinder
application menu: Menu > Set-up > Sounder Set-up >
Internal Sounder .
• External sonar modules should be turned off at the power
supply.
2. Wait for the No Sounder Source Available message to be
displayed in the Fishfinder application.
3. Power on the new sonar module.
Switching between multiple external sonar modules
If your system includes multiple external sonar modules you
must complete the procedure detailed below to ensure only one
sonar module is active at a time.
Note: If your multifunction display has an internal sonar
module, complete the procedure detailed in Switching
between internal and external sonar modules BEFORE
attempting the following:
1. Power off ALL external sonar modules, either at the power
supply or by disconnecting the power cable from the sonar
module.
2. Wait for the No Sounder Source Available message to be
displayed in the Fishfinder application.
3. Power on the external sonar module that you want to use.
6.2 Software updates
The software running on the product can be updated.
• Raymarine periodically releases software updates to improve
product performance and add new features.
• You can update the software for your product using a
connected and compatible multifunction display.
• Refer to www.raymarine.com/software/ for the latest software
updates and the software update procedure for your product.
• If in doubt as to the correct procedure for updating your
product software, refer to your dealer or Raymarine technical
support.
30 CP100