Raymarine AXIOM 2 XL, Руководство по установке

Страница: 31 / 108

7.4 Preparing the mounting surface — surface
mounting
Surface mounting requires one cut out hole. When the display is surface
mounted the glass/bezel will protrude from the mounting surface.
Note:
The following procedure is for preparing the mounting surface for
surface mount installations. For flush mounting details refer to:
p.31 — Preparing the mounting surface — flush mounting
Important:
Before preparing the mounting surface ensure that:
• your selected location meets the location requirements. For details refer
to: p.24 — Location requirements
• you have identified cable connections and the route that the cables
will take.
1. Mark the cut out line identified on the supplied mounting template on
the mounting surface.
2. Use a drill and an appropriate size drill bit or hole cutter to cut out the
corners of the Cut out line.
The corner diameter for the displays are:
• 15.40 mm (0.61 in) — Axiom® 2 XL 16, 19 and 24.
• 13.5 mm (0.53 in) — Axiom® 2 XL 22.
3. Use a jigsaw or similar cutting tool to cut out the remainder of the cut
out area.
4. Use a half round file and/or sandpaper to smooth and rough edges or
burs on the cut out hole.
7.5 Preparing the mounting surface — flush
mounting
Flush mounting requires the same cut out hole as surface mounting and an
additional rebate around the edge of the cut out. When the display is flush
mounted the glass/will be flush with the mounting surface.
Note:
The following procedure is for preparing the mounting surface for
flush mount installations. For surface mounting details refer to:
p.31 — Preparing the mounting surface — surface mounting
Important:
Before preparing the mounting surface ensure that:
• your selected location meets the location requirements. For details refer
to: p.24 — Location requirements
• you have identified cable connections and the route that the cables
will take.
Installation 31