Chapter 5: Installing the
65
5
In
stal
ling t
he
ST4
000+
Cantilever mounting
If you need to attach the tiller drive to a vertical face (such as the
cockpit sidewall), use a Raymarine cantilever socket assembly
(part number D031):
•
the maximum possible extension offset is 254 mm (10 in)
•
you cut the cantilever to the exact length during mounting
Cutting the cantilever rod to length
1. Clamp the tiller on the boat’s center line.
2. Measure dimension F (actual).
3. Refer to the table to establish a cutting length for the cantilever
rod – double check measurements before cutting.
4. Measure the rod from threaded end, then cut the cantilever rod
to length L using a hacksaw. Remove any sharp edges with a file.
Dimension F
Cut length L
686 mm (27 in)
51 mm (2 in)
711 mm (28 in)
75 mm (3 in)
737 mm (29 in)
102 mm (4 in)
762 mm (30 in)
127 mm (5 in)
787 mm (31 in)
152 mm (6 in)
813 mm (32 in)
178 mm (7 in)
838 mm (33 in)
203 mm (8 in)
'B'
D309-2
90 degrees
Содержание autopilot ST4000+
