Wuhan Raycus Fiber Laser Technologies Co., Ltd
User Guide RFL-QCW150/1500
25
Code
Description
Examples
RCT
Read Laser Temperature — Reads the internal temperature
of the laser. The response is an echo of the command, a delimiter of
“:”, and the temperature in degrees centigrade.
Sent
：
“RCT”
Response
：
“RCT:34.5”
RDGW
Read Default Gateway –Reads the current default gateway of the
device. The response is the command echoed back, followed by a
delimiter of “:” and then the default gateway in dot-decimal
notation.
Sent
：
“RDGW”
Response
：
“RDGW:192.168.0.1”
RERR
Reset Errors — Resets any resettable errors.
Sent
：
“RERR”
Response
：
“RERR”
RIP
Read IP –Reads the current IP address of the device. The response
is the command echoed back, followed by a delimiter of “:”, and
then the IP address in dot-decimal notation.
Sent
：
“RIP”
Response
：
“RIP
：
192.168.0.10“
RMASK
Read Subnet Mask — Reads the current subnet mask of the device.
The response is the command echoed back, followed by a delimiter
of “:”, and then the subnet mask in dot-decimal notation.
Sent
：
“RMASK”
Response
：
“RMASK
：
255.255.255.0”
RPRR
Read Pulse Repetition Rate — Reads the pulse repetition rate. The
response is the command echoed back, followed by a delimiter of
“:” and then the pulse width in Hz.
Sent
：
“RPRR”
Response
：
“RPRR
：
10”
(Indicates that the PRR is 10 Hz)
RPW
Read Pulse Width — Reads the pulse width. The response is the
command echoed back, followed by a delimiter of “:” and then the
pulse width in milliseconds (ms).
Sent
：
“RPW”
返回：
“RPW
：
5.5”
(Indicates that the pulse width is
5.5 ms)
SDC
Set Diode Current — Sets the diode current. The units are in
percent of maximum current. The setpoint must be below 100%
and above the minimum current setpoint. The current can also be
set to 0. The response from the laser is the command echoed back,
a delimiter of “:” and then the current setpoint for the laser. A value
that is outside the acceptable range receives a response of “ERR:
Out of Range.”
Sent
：
“SDC 34.2”
Response
：
“SDC
：
34.2”
(Current Setpoint is set to34.2%)
Sent
：
“SDC 104.2”
Response
：
“ERR
：
Out of Range”
(The setpoint is unchanged)
SDGW
Set Default Gateway —Followed by a number in dot-decimal
notation sets the default gateway for the laser.
Sent
：
“SDGW 192.168.0.1”
Response
：
“SDGW: 192.168.0.1”
SIP
Set IP — Followed by a number in dot-decimal notation sets the IP
address for the laser.
Sent
：
“SIP 192.168.0.10”
Response
：
“SIP 192.168.0.10”
SMASK
Set Subnet Mask— Followed by a number in dot-decimal notation
sets the subnet mask for the laser.
Sent
：
“SMASK 255.255.255.0”
Response
：
“SMASK
255.255.255.0”
