Rayco RG 1635A, Руководство оператора и каталог запасных частей

Страница: 18 / 104

Copyright © 2000 Rayco - All Rights Reserved
Printed in U.S.A.
RG 1635A STUMP CUTTER
RAYCO
®
18
8. Secure safety chains (7) to towing vehicle.
' Set the length of each chain, and
crisscross them to optimize their purpose
of catching the trailer tongue should the
hitch become detached. There must, at
the same time, be enough slack left to
allow for pivoting during the sharpest
turns.
To change the length of chain (7), lift the
link out of the slot in hitch mount, pull the
chain to desired length, and drop the
nearby link into the slot so that chain is
held at that length. Set length for both left
and right ends of chain; the slack may left
draping over the tongue.
' Be sure the hooks are securely attached
to towing vehicle and cannot vibrate
loose.
WARNING
If any of above tests fail, troubleshoot
lighting system, and correct problem before
towing machine on public roadways.
Pre-Starting Inspection
NOTICE
To ensure the long life and economical operation
of your stump cutter, we highly recommend that
the operator be well instructed in both the opera-
tion and maintenance of this machine.
Inspect the machine and perform each of the '10
Service Hours or Daily' (See '
Maintenance ' section)
maintenance inspections and services as found nec-
essary before operating the machine.
O
PERATION
Starting the Engine
WARNING
Understand and decide to heed the •Safety•
section of this manual, in its entirety, before
proceeding.
NOTICE
Do not operate the starter for more than 20 sec-
onds at a time. To do so may overheat the starter.
If the key switch is released before the engine
starts, wait until the starter and the engine stops
turning before trying again. This will prevent pos-
sible damage to the starter and/or flywheel.
If the engine does not start the first time, wait at
least 1 minute before trying again. If it does not
start after 2 attempts, see the •Trouble Shooting•
section of the
Wisconsin [Engine] Operation
Manual.
Use starting fluid only while simultaneously
cranking engine, and dispense only with an
apparatus approved by the engine manufacturer.
WARNING
D O N O T s t a r t c u t t i n g w h e e l d r i v e u n t i l
machine is in cutting position, next to stump!
Starting
1. Insert key into start switch.
2. Open engine speed control throttle 1/4 of the
way.
3. Turn the key clockwise, to engage the starter,
and hold it there momentarily as the engine
cranks. Release the key when the engine starts
firing, and the key will automatically return to
the RUN position.
4. Reduce the engine speed as soon as it is
running smoothly.