PIPe FReeze PROTeCTIOn AnD FLOW MAInTenAnCe
32 of 44
www.tycothermal.com
H55838 2/12
Table 18 Control Systems
Catalog number
Description
Electronic Thermostats and Accessories
eC-TS
electronic thermostat housed in a neMA 4X enclosure with 2 x 1/2-in conduit entries for
power and one gland entry for the sensor . The temperature set point and LeD indicators
for alarm, power, and heating cable status can be visually checked through the clear lid .
electrical rating is 30 A at 100–277 V, 50–60 Hz, SPST switch . eC-TS includes a 25 ft
(7 .6 m) sensor .
SB-110
Pipe mounting bracket for eC-TS
Electronic Controllers and Sensors
C910
C910-485
The C910 is a compact, full-featured microprocessor-based single-point heat-trace control-
ler . The C910 provides control and monitoring of electrical heat-tracing circuits for both
freeze protection and temperature maintenance, and can be set to monitor and alarm for
high and low temperature, high and low current, ground-fault level, and voltage . The
DigiTrace C910 controller is available with an electromechanical relay (eMR) for use in
ordinary areas . The C910-485 comes with an RS-485 communication module .
ACCS-UIT2
ACCS-PCM2-5
The DigiTrace
ACCS-30 Advanced Commercial Control System is a multipoint electronic
control and monitoring system for heat-tracing used in commercial freeze protection and
flow maintenance applications . The DigiTrace ACCS-30 system can control up to 260 circuits
with multiple networked ACCS-PCM2-5 panels, with a single ACCS-UIT2 user interface ter-
minal . The ACCS-PCM2-5 panel can directly control up to 5 individual heat-tracing circuits
using electromechanical relays rated at 30 A up to 277 V .
By FieldServer Technologies
www.ProtoCessor.com
P
ROTO
C
ESSOR
SERIAL ETHERNET
P
ROTO
N
ODE
FRAME GND
- PWR
+PWR
RS 485+
RS 485 -
RS 485 GND
S3
S2
S1
S0
B3
B2
B1
B0
A7
A6
A5
A4
A3
A2
A1
A0
Protonode-LeR
Protonode-ReR
The DigiTrace Protonode is an external, high performance multi-protocol gateway for
customers needing protocol translation between Building Management Systems (BMS) and
the DigiTrace ACCS-30 or C910-485 controllers .
The Protonode-LeR is for LonWorks
®
systems; and the Protonode-ReR is for BACnet
®
or
Metasys
®
n2 systems .
RTD-200
RTD3CS
RTD10CS
Three-wire RTD (Resistance Temperature Device) used with DigiTrace C910 and ACCS-30
controllers .
RTD-200: 6-ft (1 .8 m) fluoropolymer with 1/2-in nPT bushing
RTD3CS: 3-ft (0 .9 m) flexible armor with 1/2-in nPT bushing
RTD10CS: 10-ft (3 m) flexible armor with 1/2-in nPT bushing