Rayburn STRATUS 100-30 XS, Инструкция по установке и эксплуатации

Страница: 5 / 29

5
Carefully remove the appliance from the box.
Prior to installing the appliance, test to make sure the appliance operates properly by
plugging the power supply cord into a conveniently located 230V electrical socket.
Test all aspects of its operation (manual switches, remote and heater) to make sure all
components operate correctly.
As with most electronic devices, your new electric fireplace has been designed to operate at
temperatures between 5
℃
and 3 5
℃
. During the cold winter months, allow the fireplace to
reach room temperature before turning it on.
NOTE:There maybe trace of odor during the first few minutes of initial use.This is
harmless, normal and will never occur again.
Plan where to locate and frame the fireplace. This will save time and money later when you
install the fireplace. Before installation consider the following:
1. Where the fireplace is located must allow for wall and ceiling clearances.
2. Consider a location where the fireplace screen will not be exposed to direct sunlight from
windows or doors.
3.
The appliance must be wired into a separate single phase power supply 230V~50Hz,
13amp fused spur. The fused spur/socket must be accessible at all times and must not
be placed behind the unit. The mains socket must be accessible to ensure the appliance
can be safely disconnected when required.
4.
On built in units the connection must be made using a 13 amp switched fused spur, the
switch must be accessible at all times, to connect to a fused spur trim the power cord
provided.
WARNING – ELECTRIC SHOCK HAZARD
It is the customers responsibility to contact a qualified
electrical installer to make sure the electrical installation
is adequate and in conformance with the regulations.
Take special care when cutting holes in walls or floor.
Electrical wires may be behind the wall or floor covering
and could cause an electrical shock if you touch them.
Locate any electrical circuits that could be affected by the
installation of this product and disconnect power circuit.
WARNING: THIS APPLIANCE MUST BE EARTHED.
DO NOT use an extension lead with this appliance.
The appliance is designed for the voltage stated on the
data plate.
Recommended but not mandatory to fit an individual
Residual Current Device (RCD) to the cooker supply
circuit.
Hand this Manual to the User for retention and instruct
in the safe operation of the appliance.
UNPACKING AND TESTING APPLIANCE
LOCATING THE FIREPLACE