14
P
Residual Heat Indicator
The hob surface will get hot when in use, this is due to heat
being conducted from the cooking pan. The hob surface will
also remain hot for a while after use.
After the cooking period the hob hot indicator (
) will
be displayed and for a short period of time after power off.
Control Panel
Always use positive finger contact on the touch pads to
ensure a good control response.
Touch pads may not respond if the hob control area is wet.
Touch pad area should be dried using paper towel.
Overheat Protection
Power levels will be automatically reduced if excessive high
temperatures are monitored below the cooking zone. If high
temperatures are detected it will not be possible to adjust
the power level to a higher level than shown in the visual
displays.
Should a pan be allowed to boil dry the overheat system will
turn the hob off.
P
P
P
Using the Induction Hob
Step 1.
To switch on touch the Power ON pad.
Step 2.
Touch the induction on. If power level is not set
within 10 seconds the unit will automatically switch off.
Step 3.
Set the required power level from 1- Boost, if
Boost is selected it will last for 10 minutes them revert to
a lower setting.
P
Fig. 8.3
Step 4.
To switch off touch the Power OFF pad.
