Rayburn 200G/L, Инструкции по установке и обслуживанию

Страница: 1 / 16

The Rayburn 200 G/L Cooker provides cooking facilities
only, and is suitable for Natural Gas. A single atmospheric
gas burner is thermostatically controlled at cooking rates,
and operates at a low bypass rate when idling.
The exhaust flue connection of the appliance is in Open
Flue form, operating on natural draught.
Facilities included on the cooker are, a heat graduated
hotplate, main oven and lower oven. A timing programmer
is also available, as an optional extra.
Gas connection 15mm O.D. copper
Open flue outlet 100mm (4in. int)
Electric Supply 240V ~ 50Hz 3 amp fused
Weight of Appliance 275kg
Installation Instructions
The appliance must be installed in accordance with these
instructions, local gas fitting regulations, municipal
building codes, electrical wiring regulations, the AGA Gas
Installation Code and any other relevant statutory body.
In your own interests, and that of safety to comply with the
law, all gas appliances to be installed by authorised
persons, in accordance with the above regulations.
Failure to install appliances correctly could lead to
prosecution.
Installation and Servicing Instructions
for Rayburn 200G/L
Gas Fired Cooker
AUSTRALIAN MARKET
Certificate of Approval No. 5013
1
01/10 EINS 512070
INTRODUCTION INSTALLATION INSTRUCTIONS
Technical Specification
Natural Gas
Heat Input 5.6kW
Pressure G20 20mbar
G25 25mbar
Injector Size 1.82 Bray 460
Pilot Size 38/36A
Propane
Heat Input 20MJ/h
Inlet Pressure Propane 2.75 kPa
Injector Size 1.27 Bray 220
Pilot Size 4209
IMPORTANT NOTICE: Any alteration that is not approved by AGA,
could invalidate the approval of the appliance, the operation of the
warranty and could also affect your statutory rights.
Control of Substances - Health and Safety
Important
This appliance may contain some of the materials that are indicated
below. It is the Users/Installers responsibility to ensure that the
necessary personal protective clothing is worn when handling, where
applicable, the pertinent parts that contain any of the listed materials
that could be interpreted as being injurious to health and safety, see
below for information.
Firebricks, Fluebeds, Artificial Fuels – when handling use
disposable gloves.
Fire cement – when handling use disposable gloves.
Glues and sealants – exercise caution – if these are still in liquid
form use face mask and disposable gloves.
Glass Yarn, Mineral Wool, Insulation Pads, Ceramic Fibre,
Kerosene Oil –
may be harmful if inhaled. may be irritating to skin,
eyes, nose and throat. When handling avoid, inhaling and contact
with skin or eyes. Use disposable gloves, face-masks and eye
protection. After handling wash hands and other exposed parts.
When disposing of the product, reduce dust with water spray, ensure
that parts are securely wrapped.
raywarranty@aga-web.co.uk