Raveon RV-M7, Техническое руководство

Страница: 22 / 67

RV-M7 Technical Manual
22
Even though the serial baud rate reverts to 9600 baud when the CONFIG button is pressed
and the IO port is RS-232, it will revert back to the settings programmed into the
M7 modem
once the Command Mode is exited.
Note: If the user-interface is password protected, and the Config button on the M7 is pressed,
for security reasons, the encryption phrase is automatically erased.
5.7 Exiting the Command Mode
There are three ways to exit the command mode. They are:
1. ATCN Issuing the ATCN . The M7 radio will exit the command mode, and begin normal
operation.
2. EXIT Issuing the EXIT . The M7 radio will exit the command mode, and begin normal
operation.
3. Time Out . After a pre-set amount of time (60 seconds is the factory default time), the
modem will automatically exit the Command Mode, and continue normal operation.
Changes will not automatically be saved. This time-out duration may be set with the
ATCT
command.
5.8 Password Protection
On M7 series products with firmware version C0 or higher, the user interface may be password
protected. If it is password protected, the radio will output a “password:” prompt when
entering the command mode.
When in the command mode, to enable the use of a password enter:
Password xxxx <CR>
Where xxxx is the 2-7 digit password you would like to protect the user interface with.
To disable password protection, enter:
Password 0 <CR>
Note: If the user-interface is password protected, and the Config button on the M7 is pressed,
for security reasons , the encryption phrase is automatically erased.