Raveon RV-M7-GX, Быстрый старт

Страница: 7 / 19

M7 GX Quick Start Guide
7
Raveon Technologies
6. Configuring the M7 GX
6.1. Overview
There is a “Command Mode” used to program and
configure the
M7 GX . In the Command Mode, the M7 GX
modem accepts commands via the serial port and the user
may configure the internal parameters of the unit, such as
frequency and ID codes.
6.2. Command Mode
The M7 GX modem ma
y be put into a “Command Mode”, by
entering a sequence of three plus characters (+++). Using
serial communications software such as
HypterTerminal ,
send the 3-
character command sequence “+++”.
When the M7 GX modem first enters the Command Mode, it
sends its model number out its serial port, and then an
“OK”.
6.3. Setting a Parameter
To set a parameter in the M7 GX modem, enter the
Command Mode as described above, then enter the proper
command, a space, the parameter, and then a carriage
return. For Example, to set the destination address of the
M7 GX modem to 25, enter the following command:
ATDT 25 <CR>.
6.4. CONFIG Button
There is a small push-button inside the M7 to assist. This
“CONFIG” button may be pressed at any time, and forces
the
M7 GX into a known state. The CONFIG button is
located inside the M7 GX .
The default settings that the M7 GX will revert to when the
CONFIG button is pressed are:
1. Serial port 9600 baud, 8 data bits 1 stop, no
parity
2. Serial port flow control is off.