M7 GX Quick Start Guide
12
Raveon Technologies
Even if the unit is not moving, the GPS
periodically measures position and
speed to determine if it has triggered a
speed or position transmission.
6.6. Factory Default Settings
For the UHF
M7 GX
model RV-M7-UC-GX, the factory
defaults GPS settings are:
Radio channel 1 ........................ 464.500 MHz
GPS Mode ................................... 4 (Use with GPS
display)
Over-the-air baud rate: ................. 4800 baud, 2-level
Serial port .................................... RS-232, 4800baud,
N/8/1
Hardware flow control ................... Off
RF Power Output ......................... 5 watts
Channel number selected ............. 1
Position/Status report interval ....... 10 seconds
Security KEY ................................
RAVEON
Proximity Alert .............................. 0, off.
I/O Change reporting .................... 0, off
ID Prefix ....................................... V
SLOTTIME ................................... 200mS
TXRATE ....................................... 10 seconds
7. Setup and Initial Configuration
1.
Connect a DC power source to the DC IN connection
on the front Connect a DC power source to the DC IN
connection on the front of the modem.
2.
Connect a good quality antenna, cut to the operating
frequency, to the BNC connector on the front of the
modem.
3.
Connect a computer terminal, or PC computer
running HyperTerminal, to the 9-pin I/O connector.
The factory default serial ports settings are 4800 bps,
8 data bits, 1 stop, no parity.
