Atlas PT Technical Manual
19
Command
Command Description
Parameter
s
Factory
Default
ACK0
Clear all alerts
.
Will reset all alert flags
(both user-initiated and hardware
generated). An alert flag will re-appear if the
triggering condition has not ceased.
N/A
N/A
ACK1
Acknowledge user alert.
Intended for
over-the-air commanding. Changes the alert
LED from orange to green. Returns NACK if
the unit is not in a wearer-initiated alert.
N/A
N/A
ACK2
Clear user alert states.
Turns off the alert
LED if it is on and resets the user alert
sequence. Returns NACK if the unit is not in
a wearer-initiated alert or ACK state.
N/A
N/A
ALERT
The
ALERT x
command may be used to
read the alert condition and control the alert
feature via the serial port, or over-the air
using RPR commands. 0=none, 1= normal,
2=critical alert, 3=acknowledged.
Alert 2 will fail if the radio is configured
to have only one alert mode.
1-3
0
ALERTLEVELS
Number of Alert Levels.
If set to 1, the
alert led will only ever turn Orange or Green
and only the “A” alert will ever be
transmitted.
If set to 1 while in Critical Alert (ALERT 2),
the alert level will downgrade to Alert.
1-2
2
ALERTCAN
Enable/disable local Alert cancellation.
If
set to 1, alerts will not cancel when the alert
button is held. Alerts can only be cancelled
via the serial or RPR.
0 or 1
0
ATCM
RS-232 power saving mode.
The serial
port will be in receive-only mode on startup
until a character is received.
0 or 1
0
ATTX
Transmit Channel Access Method.
Enables TDMA operation. 0=standard
carrier-sense. 1=TDMA.
1 - 6
1
ATHX
Singe-hop repeat.
Only applicable if
repeater function is enabled. (ATXR = 1)
0 = repeater will repeat as programmed. 1
= will not repeat any packet that has already
been repeated.
0 or 1
0
ATMC
Set/Read Channel Access Method.
0=Standard carrier-sense CSMA. 1=Time-
Division Multiplex, where user-data is
transmitted in the unit’s TDMA slot.
0 or 1
0
GPS
GPS Operation Mode.
Set the SM
version’s Operating mode.
1
– 9
1
GPS&F
Reset all GPS (-SM version) parameters.
Set the SM version’s Operating mode to
GPS mode 4, and sets all GPS parameters
to factory defaults. It does not erase
frequency or other radio-related
parameters.
-
-
IDLERATE
IDLE TX Interval.
Set the number of
seconds between position transmissions
when the unit is idle (has not moved more
than TRIGDX meters).
0-9999
seconds
10
KEYPHRASE
Privacy Security Key Code.
Set the
privacy key for this device. It must be the
same key as used on all other Raveon
2-16 ASCII
characters.
“RAVEON”
