Raven viper, Инструкция по установке и эксплуатации

Страница: 74 / 182

C
HAPTER
8
66 Viper/Viper 4+ Installation & Operation Manual
13. The General Information tab allows the operator to enter or modify machine information. Touch the
information fields and use the on-screen keyboard to enter general information about the machine for
identification purposes. If a preset machine profile was selected, verify the information displayed and make
adjustments if necessary.
14. Press Next.
15. Set or adjust the GPS Offset measurements and Antenna Height. Refer to the Measurements Tab section on
page 79 for assistance with measuring these values.
16. Enter the Wheel Base measurement. Refer to the Measurements Tab section on page 79 for assistance with
measuring the machine wheel base.
17. Press Next.
18. Review the section information. If a preset machine profile was selected, the section information for the
equipment available from the manufacturer will be set for section groups as appropriate. Touch:
•
the Delete button to remove section groups from the machine profile
•
the Edit button to modify sections labels, widths, or offset information
•
the Add button to create a new or customized section group
Refer to the Section Groups and Section Settings section on page 72 for more information on setting up
implement section groups.
EDIT THE CURRENT MACHINE PROFILE
To make adjustments to the current machine profile:
1. Touch the Edit icon in the Machine Panel to view the machine devices.
2. Touch the Machine Profile button to access the profile settings.
3. Select the General Information tab and enter identification information for the machine. Refer to the General
Information Tab section on page 77 for additional information on machine identification or the Machine
Profiles section on page 63 for assistance with creating or modifying machine profiles.
4. Select the Measurements tab and adjust GPS offset values and the machine wheelbase. Refer to the
Measurements Tab section on page 79 for assistance with measuring these values on various vehicle types.
5. Select the Equipment tab to view configured section groups. Review the Section Groups and Section Settings
section on page 72 for additional information on creating, editing, or deleting section groups.
6. Use the page navigation buttons at the bottom of the machine profile tabs, or swipe from left to right, to
access the machine configuration Information tab.
7. Use this page to modify the machine configuration information or override the implement width or offset
information used for field guidance. Refer to the Machine Configuration Tab section on page 76 for more
assistance with the machine configuration information.
Edit Measurements
Machine
Panel
General
Information
Equipment Machine
Configuration