Raven viper, Инструкция по установке и эксплуатации

Страница: 149 / 182

Guidance Screens and Widgets: 141
GUIDANCE SCREENS AND WIDGETS
14
GPS WIDGETS
FORWARD OVERRIDE
The Forward Override widget may be necessary if the reverse sensing feature is enabled. Refer to the
GPS Reverse Sensing section on page 88 for more information about the Reverse Sensing feature. If
ROS detects reverse vehicle travel, tap the forward override widget to manually override ROS to a forward
direction of travel.
GPS STATUS
The GPS Status widget may be used as a status indicator for signal reception used for the
current position solution. This widget will display the selected and current correction type and
status for NMEA messages received by ROS during field operations.
Touch and hold the widget to access a GPS Health prompt with additional details on GPS reception. Refer to the
Raven Receiver Settings Definitions section on page 96 for definitions of the information displayed on the GPS
Health prompt.
GPS SUMMARY
The GPS Status widget provides an indicator for signal reception used for the current position solution
and the current speed detected by the GPS receiver. This widget will display the selected and current
correction type and status for NMEA messages received by ROS during field operations.
Touch and hold the widget to access a GPS Health prompt with additional details on GPS reception. Refer to the
Raven Receiver Settings Definitions section on page 96 for definitions of the information displayed on the GPS
Health prompt.
HEADING AND SPEED WIDGET
The Heading and Speed widget displays the current GPS heading and vehicle speed as
detected by the receiver. Touch and hold this widget to access the GPS Health prompt with
additional details on GPS reception. Refer to the Raven Receiver Settings Definitions section on page 96 for
definitions of the information displayed on the GPS Health prompt.
NOTE: The GPS filter mode allows the operator to filter the course over ground information provided for
position information during field operations. Higher filter settings may be desirable in some regions
to help smooth rapid course variations reported by the GPS receiver and provide smoother course
information on job reports.
The default filter setting is Low (this is the recommended setting). Raise the filter mode setting to
increase the filtering capabilities if GPS corrections in your region normally create erratic or
fluctuations in GPS course over ground information, or create other issues during field operations or
on job reports.
VEHICLE SPEED
The Vehicle Speed widget displays the current vehicle speed as reported by a speed sense node on the
CANbus. The speed displayed using this widget is the speed to which a rate control system will be using
for speed compensated rate control systems.