Raven viper, Инструкция по установке и эксплуатации

Страница: 104 / 182

C
HAPTER
9
96 Viper/Viper 4+ Installation & Operation Manual
RAVEN RECEIVER SETTINGS DEFINITIONS
The settings defined in the following sections will be available only for integrated or compatible Raven receivers. If
a compatible receiver is not detected by ROS, the following settings will not be accessible. Check any cable
connections and refer to the Serial Device Detection section on page 105 to reinitialize the serial communication
ports.
DIFFERENTIAL SETTINGS TAB
1. Touch the Edit icon in the Machine Panel to view the machine devices.
2. Locate and select the GPS module. The GPS Global Settings prompt will display.
3. Click the Configuration icon to the right of desired receiver. The differential settings tab will open.
4. Select one of the following differential types available along the left side of the differential settings prompt:
NOTE: The settings and options displayed on the Differential Settings prompt will vary based upon the
selected differential type. Refer to the descriptions below for additional information and refer to the
definitions section for each specific correction type for additional assistance with settings and
options.
GL1DE Only. For areas with limited availability of differential correction sources (e.g. SBAS, OmniSTAR, etc.), the
ROS device may offer Autonomous GL1DE as an autonomous GPS correction source. In Gl1de only mode, ROS
will use GPS satellites to locate the vehicle position within 20 in [50 cm].
NOTE: No additional settings or features are available for the Autonomous GL1DE correction type. Refer to
the specific ROS device manual or contact a local Raven dealer for more information on capabilities
of a specific ROS device or display.
RTK. The Real-Time Kinematic (RTK) correction type uses a Slingshot
®
Field Hub, a Continuously Operating
Reference Station (CORS) network, or a traditional base station system for a position solution. These systems
use a ground reference station to provide highly accurate corrections.
NOTE: The RTK option will be displayed only after an RTK authorization key is entered using the procedure in
the Authorizing a DGPS Receiver Feature section on page 92. Contact a local Raven dealer to obtain
the authorization code or for more information on the Slingshot RTK services.
Refer to the RTK section on page 100 for additional information on available settings or options
available for the RTK correction type.
GS-Satellite. The GS correction service is a satellite based subscription service providing position solutions using
GPS and GLONASS satellite constellations and using a Precise Point Positioning (PPP) technique to remove
atmospheric errors to determine a position solution. Contact a local Raven dealer or access the Slingshot store at
the web address below for additional subscription information.
https://ravenslingshot.com/store
SBAS. The Satellite Based Augmentation System (SBAS) option utilizes the available Wide Area Augmentation
System (WAAS) or European Geostationary Navigation Overlay Service (EGNOS) correction signals. These
common correction services are available free for use in several regions and is the default correction source if
available on the selected receiver.
Refer to the SBAS section on page 97 for additional information on available settings or options available for
the SBAS correction type.
Edit GPS Configuration
Differential
Settings