Raven TC1/HDU, Руководство по установке

Страница: 14 / 26

CHAPTER 3
10 TC1/HDU Installation Manual for Versatile 380, 405, 430, 460, 520, 570, and 610 (Steer Ready)
INSTALL THE FOOT SWITCH (OPTIONAL)
FIGURE 5. Foot Switch Installed
1. Select a suitable location for the foot switch (P/N 063-0172-470) to be installed.
NOTE: The foot switch should be installed in a location where the operator has easy access to it and is able
to fully press the pedal.
2. Using the holes in the foot switch as a template, drill holes in the floor of the cab.
3. Secure the foot switch to the floor by installing the supplied screws in each of the mounting holes.
4. Route the foot switch cable connector to the node mounting location.
INSTALL THE NODE HARNESS
1. Connect the 12-pin Deutsch connectors on the (P/N 115-4010-127) to the HDU and TC1. The gray and green
connectors go to the TC1, while the gray and black connectors go to the HDU.
NOTE: Nodes are keyed to prevent connecting matching colors to the wrong node.
2. (Optional) Locate the ENABLE connector on the node harness and connect it to the foot switch cable
connector.
3. Connect the yellow and blue ring terminals in the same conduit to the ground bar behind the seat.