Raven SmartRow, Руководство по установке

Страница: 20 / 26

Chapter 4
16 SmartRow Installation Manual
Installing the Power Harness and Planter
Harness
Parts Needed for this Procedure
To Install the Power Harness
Note:
Refer to the “SmartRow Installation and Operation Manual” for instructions on mounting
the SmartRow console.
1.
Connect the power harness to the SmartRow console.
a.
Locate the 20 pin connector on the SmartRow power harness (P/N 115-3001-020) and
connect to the Control receptacle on the rear of the SmartRow console.
b.
Locate the 4 pin connector on the SmartRow power harness (P/N 115-3001-020) and connect
to the Power receptacle on the rear of the SmartRow console.
2.
Route the power harness to the rear of the cab.
3.
Locate a source of 12V switched power.
4.
Referring to the SmartRow power harness (P/N 115-3001-020).
a.
Connect the red wire to clean source of 12V switched power.
b.
Connect the white wire to a source of ground.
5.
Route the power harness to the hitch and secure with the supplied tie straps.
Note:
Be sure to allow enough slack in the harness to allow for the machine movement
(articulated tractors) in order to prevent pinching or stretching of the harness.
Component Part Number Quantity
SmartRow Air Clutch Power Cable 115-3001-035 1
SmartRow Clutch Cable for Clutch System 115-3001-019 1
SmartRow Console 063-0172-828 1
6’ GPS Cable 115-0171-119 1
12’ Receiver Cable 115-0171-460 1