PAGE 29/36 |
Installation manual
|
016-8000-028EN
|
Rev. B
CRX/ ROS INSTALLATION | CRX/VIPER 4+ ROS - RS1 | RAVEN EUROPE GENERIC
MASTER SWITCH
The master switch can be used to switch high current
power off during road transport.
Connect the 6-pin connector of the CABLE, 6P TO DT
MASTER SWITCH 21X36 (115-8000-411) to the 115-
8000-157 cable.
Install the
MASTER SWITCH AUTO PILOT
switch (063-
8000-149) in the armrest or dashboard in a convenient
position for the tractor driver (Figure 33).
Connect the 115-8000-411 cable to the 063-8000-149
master switch.
ENGAGE
Select a suitable location to install the push button or
foot switch.
Note: the push button or foot switch should be
installed in a location where the operator has easy
access to it and is able to fully press the button or
switch.
Using the holes in the foot switch as a template, drill
holes in the floor of the cab. Secure the foot switch to
the floor by installing the screws in each of the
mounting holes.
In the case of a push button, drill a hole in the panel or
armrest and mount the push button (Figure 34).
Route the push button or foot switch connector to the
engage connector of the 115-8000-157 cable (Figure
35).
FIGURE 34 PUSH BUTTON MOUNTING
FIGURE 33 MASTER SWITCH AUTO PILOT BUTTON
FIGURE 35 RESUME FOOT SWITCH CONNECTION
