SBGuidance I Rev. A I IntelliSteer
Pag 11/22 I SBG-IntelliSteer-IM-EN-Rev. A
On the side of the exhaust is a pressure sensor
mounted on the CNH steering valve (Figure 6).
Connect the 3-pole Delphi connector of the STU
– NH Intellisteer harness with inscription
‘’pressure sensor’’ on the steering valve.
5.
Harness CNH STR WHS – Spy: First disconnect the
excisting connection of the CNH steer angle
sensor. This connection is located on the right
side of the tractor next to the radiator (Figure 7).
Then connect the two connectors of the NH STR
WHS – Spy harness between the excisting CNH
wheel angle sensor. (Figure 7)
Pay attention!: Do not connect the connectors of
the NH STR WHS – Spy harness on the dummy
connector which is also located nearby the
radiator. Connect the connectors of the harness
between the excisiting connection.
6.
Wheel sensor cable: The next step is to connect
the wheel angle sensor cable (5m) (SBG11901-08)
to the NH STR WHS – Spy harness with the wheel
sensor connector of the STU – NH intellisteer
connector.
A schematic overview of the SBG CAN-harness on a
CNH Intellisteer Ready tractor is shown in Figure 8.
Figure 7 Connection of the STU – NH intellisteer
harness to the wheel angle sensor.
Figure 6 Connection of the STU – NH intellisteer
harness on the CNH pressure sensor
