3
Manual No. 016-0130-076 Rev. C
11
Calibration
4.
Verify that the Center Rack Control option is selected.
Note:
Be sure that the required components for center rack control are installed prior to enabling the
center rack control feature.
5.
Select the Calibrate tab.
6.
Touch the master power icon at the bottom of the tab to toggle the AutoBoom
system on.
7.
On the implement joystick or control panel, press and hold the center rack raise
function for 6 seconds.
Note:
Continue to hold the raise function for the full 6 seconds even if the center rack reaches the upper
limit of travel during this time.
8.
On the implement joystick or control panel, press and hold the center rack lower function for 6 seconds.
Note:
Continue to hold the lower function for the full 6 seconds even if the center rack reaches the lower
limit of travel during this time.
UltraGlide Calibration
Important:
Read and perform the process outlined in the Pre-Calibration Hydraulic Diagnostics section on page 8
before starting the calibration process.
Boom Calibration
1.
Touch the Edit icon in the Machine Configuration panel to expand the panel.
2.
Locate and select the AutoBoom button. The AutoBoom Features tab will be displayed.
Note:
If the AutoBoom button is not displayed or displays as unavailable, refer to Chapter 5,
Troubleshooting, to diagnose and correct issues with the AutoBoom control node.
3.
On the Features tab, select the options desired for operation of the AutoBoom system. Refer to the
section on page 14 for additional information on any available features.
4.
Touch the Sensor Offsets tab to access sensor height offset settings. Refer to the
section on page 15 for details on setting or adjusting the sensor offsets.
5.
Select the Calibrate tab to access the AutoBoom calibration.
6.
Use the up or down arrows to set the desired target height which the AutoBoom system should maintain
when engaged.
Master Off
Master On
Edit
AutoBoom
Features
Sensor
Offsets
Tuning
Calibrate
