Raven 500QR, Руководство пользователя

Страница: 27 / 52

5.2.5 Alarm
5.2.5.1 Motion
Click [Main menu

Alarm

Motion] to enter into the interface shown as Picture 5-42.
Latch time: you can set how long the buzzer will sound when object move is detected (10s, 30s, 40s, 60s);

Show Message: You can set show message on the screen when motion alarm is detected.

Buzzer time: you can set how long the buzzer will sound when motion is detected (off, 10s, 30s, 40s, 60s);

Send Email
：
Allows you set the alarm images is issued to a specified email.

Full screen Alarm: The function is defaulted to “On". When the motion is detected, the corresponding channel will
be switched to the full screen mode.

Record Channel: the record channel will be activated when the object move is detected.

Post Recording:
you can set how long alarm record will last when alarm ends (30s, 1minutes
，
2minutes
，
5minutes).

Copy: allow you copy current channel parameters to any other channel or all channels.

Channel: allow you enable/disable the
motion function for any channel.

Area: Click the [Setup] button to enter
into area setup interface shown as
Picture 5-41.

Sensitivity: allow you to set sensitivity
level of motion detection from higher to
low with 8 being the most sensitive.

Alarm out: allow you connect external
alarm sensor.
Picture 5-42
Picture 5-43
The channel will be separated into a 44x36 grids
(PAL/NTSC mode). When any object moves into the
motion detection area, and the area where the object
is located is displayed in red and motion detection will
be triggered. In the semi-transparent area the motion
detection is not activated.
After configuring the above parameters, click <OK> to
save it.
22