Ravelli Flexi 7, Руководство по эксплуатации и обслуживанию

Страница: 30 / 60

Manuale uso e manutenzione Flexi 7-9
Pag.30
Rev.0 18/05/2020
Connections
📌
The connections must be set up by a technician that is qualified and/or authorised by the Manufacturer.
📌
By the installer the type of cable, with relative section, to be installed in case of replacement is: H05RR-F sez.3G0,75
Connection with external air intake
The stove has been designed for hermetic installations.
To make the connection with an external air intake, proceed as follows:
step action
1
Connect a 50 mm diameter pipe to the combustion air inlet pipe at the back of the stove.
Note: the pipe must be no
more than 2 m in length.
⚠
The air vent must be installed in such a way that it can not be blocked.
Chimney connection
⚠
The chimney must be sized so as to guarantee the draught declared by the Manufacturer.
Electrical connection
The plug of the stove’s power cable must only be connected after the installation and assembly has been completed
of the appliance, and must remain accessible after installation.
To make the electrical connection, proceed as described below:
First connect the power cable to the plug on the back of the stove and then to a wall socket.
Supply power to the stove by turning the switch to position (I).
📌
When the stove is not in use, it is advisable to disconnect the power cable.
⚠
Take care that the power cord (and any other cables outside the equipment) do not come into contact with hot surfaces.
⚠
Ensure that the electrical system is grounded.
⚠
For direct connection to the mains, it is necessary to provide a device that ensures disconnection from the mains, with a
contact opening distance that allows complete disconnection under the conditions of overvoltage category III, in accordance
with installation rules
⚠
If the power supply cable is damaged, it must be replaced by the manufacturer or its technical assistance service or in any
case by a person with similar qualifications, so as to prevent any risk.
⚠
It is recommended that authorized personnel pay special attention to the electrical connections after any work on the product.
Switch
Power plug
Fuse