P/N RE - 102 / 104 Rev. No. 0
26
5.2
Installation/Replacement of PCB:
Remove the screws of PCB, which has to be changed
and remove the PCB from the mounting position and place
the new PCB in that same position with the screws tightened
properly.
5.3
Test:
This feature is used to test whether the LED and zone
card is working properly or not.
To test a particular zone, follow the procedure as below
1.
Press the ‘menu’ key zone1 selects first.
2.
Press ‘cursor’ key consequently until select the zone
which is to be test.
3.
After selecting the zone press the ENTER KEY
4.
After the ENTER KEY is pressed, Select the ‘Zone Test’
using the cursor key then press enter key, Open ,
Short & Fire test is Performed for that particular
zone.
Once the testing procedure is finished, the previous
conditions of the panel are retained.
5.4
Lamp Test:
The lamp test function done by pressing ‘ENTER’ key in
system (Panel) is normal condition. In this mode we can check
that all the LED’s are working in good condition by glowing all
LED’s.
Содержание RE -102
