Ravas 100 Series, Руководство пользователя

Страница: 21 / 23

21
Attention : during the start-up sequence of the indicator a calibration number is briefly shown in the
display. This number is changed automatically after each calibration. In case of legal for trade
systems, this number is recorded by the approving official, so that one can always verify whether a
later calibration has been done by non-authorised persons.
To view the calibration number:
 Switch the system off and then on again.
❏
The indicator shows the following sequence:
 8888.8 (testing LCD segments)
 7.x (software version)
 13425 (the calibration number)
 (current weight, standard weigh mode).
6
PARAMETER SETTINGS
 Switch off the indicator.
 To activate the parameter menu press and hold the on/off-key until the indicator shows “P 01”
(approx 23 seconds).
❏ The indicator shows: “P 01“.
 Press the  0/T  key.
❏
The indicator shows the current value of parameter P 01.

Use keys  and  to change the current value.
 Confirm with  0/T  .
❏
The indicator shows: “P 02“. Parameter P 02 can now be changed in the same way as P 01.
❏
To scroll through the parameters press the  key until the desired parameter is reached.
❏ To jump back to “P 01”: quickly press and release the on/off-key while a parameter number is
shown in the display.
 When all desired parameters have been changed, press the  0/T  key for 3 seconds to leave
the parameter menu and to return to the weighing mode.
Listed below are all available parameters.
- Settings for specific options are indicated with an asterisk (*).
Contact the producer to check whether you have the correct hardware for this option.
If the hardware is not suitable for a certain function, it will not be possible to activate or change
that function.
- The factory settings for your board can be found in the table. Contact the producer to check which
hardware version you have.