OPERATION
It is normal for the heater to emit some odor when it is turned on for the first time, or after having not been used for a
long period of time. A burning smell may be produced by the dust on the heating element. This will disappear when the
heater has been on a short while.
1.
Choose a suitable location for the heater, taking into account the safety instructions above.
2.
Insert the plug of the heater into a suitable outlet (220-240V).
3.
Once you plug the device in, switch the thermostat on by turning it slightly to the right until you hear a characteristic
clicking sound.
4.
Then put the thermostat in the selected position turning it further right.
5.
You may adjust the device's power by means of the power switches on the side of the heater: (*) 750W – minimum
power, (**) 1250W – medium power, (***) 2000W – maximum power. For maximum power 2000W - both switches
should be on.
6.
Once the heat output control knobs are on, control lights will be lit.
7.
When the device heating elements heat to the values set by the User, the convection heater will switch off and
when the heating elements’ temperature falls down, it will automatically switch on.
8.
You can control the heating intensity for the selected heat output by turning the thermostat left (without switching
it off, you will hear a characteristic clicking sound) and to the right to MAX position.
9.
You can enable TURBO function to switch on the additional air supply which will shorten the heating phase (for
models CH-9000WT and CH-9000BT).
NOTE!
If you are not able to reach the desired temperature in room, it is necessary to use next device.
OVERHEATING PROTECTION
This device is equipped with fuse preventing overheating.
WARNING!
In the event that the thermal fuse is automatically engaged and the device is turned off due to the danger of overheating, it
is necessary to disconnect the power cord from power source and to wait approx. 15 minutes until the device cools down.
Only then will it be possible to turn it on again.
CLEANING THE HEATER AND MAINTENANCE
•
Always un-plug the heater from the outlet.
•
Allow it to cool down before cleaning.
•
Clean the outside of the heater by wiping with a dry or slightly wet cloth and buff with a dry cloth. Do not use any
detergents or abrasives and do not allow any water to enter the heater.
DO NOT:
•
Install the device near furniture, curtains, below shelves, inside walls.
•
Cover the device when it is turned on
TRANSPORT AND STORAGE
•
When the heater is not used for long periods of time, it should be protected from dust and stored in a clean, dry
place.
•
Store out of reach of children. Protect against dust, humidity, and mechanical damage.
•
Transport in the original packaging. Protect against dust, humidity, and mechanical damage.
•
Always let the device cool down prior to storage or transport.
FAILURES
If any damage is disclosed after purchase, contact the seller.
Follow the rules in this manual.
Do not modify the product.
When the device does not work, unplug it. Check if there is power in the socket the device is connected to. If power was not
disrupted, do not attempt to repair the device on your own. Contact manufacturer's authorized service centre.
TECHNICAL SERVICE
All devices undergo a thorough post production control. If you still find any fault, you can ask technical service for help.
Before you talk to technical service, check if:
•
There is power in the wall socket.
•
You followed this manual when turning the device on.
