NKI1480B DAX60 and DAX120 Amplifiers—Installation
Page 5 of 18 (Jul-98)
Drawings, Diagrams, and Other Graphics
This document includes the following drawings, diagrams, and/or supplemental
graphics:
9
Transistor Replacement Drawing—Exploded (IL0253)
Packing List/Unpacking Procedure
Although the amplifier was thoroughly checked at the factory, we recommend that
you inspect the amplifier, the enclosed parts, and the shipping container for signs of
improper handling during shipment. In case of damage, immediately place a claim
with the dealer, the distributor from whom you purchased the unit, or—if the unit
was shipped directly to you—with the carrier.
The following parts are included with the amplifier:
Quantity
Part
Part Number
4
Rack-mounting screws for tapped holes (10-32
x ½ hex-head, SEMS, unslotted, machine)
WA202
4
Rack-mounting screws for untapped holes (10
x ½ pan-head, slotted, thread-forming)
WA102
4
#10 Tinnerman “U” type speed nuts for
untapped rack holes
AB1889
Installation
The amplifier should be rack-mounted where there is adequate ventilation, a
moderate temperature, an AC power outlet, and provisions for grounding.
The rack should have the standard 19-inch width and a vertical space of at least 5
1/4 inches (DAX6O) or 7 inches (DAX12O). It is recommended that additional
space be left above and below the amplifier to prevent hum from being introduced
into adjacent equipment (such as preamplifiers), to provide additional ventilation,
