Other Serial Port Output
Troubleshooting
Data Entry
Step 1.
Step 2.
Call in &
Answer
Logging
step 1.
step 2.
Keystroke
Monitoring
step 1.
step 2.
U
SC
to identify the architectural number and
DTMF mcssagc of any administrative phone line.
Note:
The Telecenter
Diagnostic
Program will time and date stamp input data and print or
save to disk. See detailed description in the manual for the Diagnostic Disk Program.
Dial #23: Upon hearing a long beep, hang up, or dial some additional digits (note the digits
and their scqucnce) and then hang up.
Verify that a message appears on the screen identifying the architectural number of the tested
line and the dialed digits.
This function logs the identity of any staff phone which places a call-in, as well as the type of
call-in made. Various administrative functions such as paging and answering call-ins may also
be reported.
Turn on the function at Location Code 64206 (See Programming Section).
Place several call-ins and verify that the correct architectural numbers and call-in type data is
displayed on the screen.
This function indicates which administrative phones are connected/disconnected with which
receiver and, if tones are produced, what they are. It also reports Call Control Console
keystrokes.
Turn on the function by adding 8 192 to the Receiver Time Limit at Location Code 64012 (See
the Programming Section).
Perform phone line tests while monitoring screen for keystroke monitoring data. Refer to the
following for valid codes and their meanings. Codes are shown in bold and variable data is
not. Variable data is for illustration
only and may be any valid value.
CODE EXPLANATION
Ap123
Phys
line 123 is connected to Rec 1.
A9
Rec 1 detected a DTMF digit 9.
a
Rec 1 is disconnected.
Bp201
Physical line
201 is connected to Rec 2.
B8
Rcc 2 detected a DTMF digit 8.
b
Rec
2 is disconnected.
K 2
k2
kt
kh
kr
kx
Console Numeric pad key 2 was pressed (space after K
is required).
Console Direct select key 2 was pressed.
Console Transfer key was pressed.
Console Hold key was pressed.
Console Release key was pressed.
Console page key was pressed.
Additional Codes in Version 102
and Later
$p23_15
Physical line 23 started ringing due to action from line 15.
-pl4
Physical line 14 hung-up.
+p13
Physical line 13 went from ringing to off-hook.
!p12
Physical
line
12
is AAI or DIL and has detected an incoming call.
1989 Rauland-Borg
Corporation (Orig. 10/88: Rev. l/89)
Page 15 of 30
