Rauch QUANTRON-K2, Инструкция по эксплуатации

Страница: 21 / 102

Attachment and installation
15
3
3.3 Connecting the control unit
Depending on the equipment, there are different methods of attaching the Control
unit to the winter service spreader. Schematic connection diagrams are provided:

For the standard connection on page 16 .

For the connection with the wheel sensor on page 17 .

For the connection with the wheel sensor and machine cable on page 18 .
Perform the work steps in the following order.

Select a suitable position in the tractor cabin (within the driver's field of
vision ) where you want to attach the Control unit.

Attach the Control unit using the mounting bracket in the tractor cabin.

Connect the Control unit to the 7-pin socket or to the forward speed sensor
(depending on the equipment, see
figure 3.3 to figure 3.5 ).

Connect the Control unit to the actuators of the machine using the 39-pin
machine cable.

Connect the Control unit to the tractor's power supply using the 3-pin plug
connector.
NOTICE
Note machine number!
The QUANTRON-K2 Control unit has been calibrated at the factory for the
winter service spreader with which it was supplied.
Connect the Control unit to the correct winter service spreader only.