Rauch QUANTRON-A, Инструкция по эксплуатации

Страница: 100 / 120

Spreading operation using the QUANTRON-A control unit 5
94
5.2.3 Spreading operation with one section width in border spreading mode
(AXIS-M VS pro)
During spreading, you can change the section widths step-by-step and deactivate
border spreading. The figure below shows the working screen with activated
limited border spreading and an activated section width.
Figure 5.3: Operating screen, one section width on the left, border spreading
side on the right
[1] Quantity change in boundary spreading mode
[2] Right spreading side in border spreading mode
[3] Right spreading side is activated
[4] Reduce or increase section width on the left
[5] Left section width gradually adjustable (VariSpread pro)

The spreading quantity on the left is set to the full working width.

The Right border spreading function key has been pressed, border spread-
ing has been activated and the application rate has been reduced by 20%.

Reduce left spreading width function key.

Press the C/100% function key to immediately return to the full working width.

Only for TELIMAT versions without a sensor: By pressing the T key, border
spreading is deactivated.
NOTICE
The border spreading function is also possible in automatic mode with GPS
Control. The border spreading side must always be operated manually.

See Page 100 .
3
5 1
2
4