Rauch AXIS-M 20.2 EMC, Инструкция по эксплуатации

Страница: 59 / 236

Technical data
39
4
AXISAXIS
4.4.10 Steps (AXIS 30.2, AXIS 40.2)
The steps support you when entering the hopper, in particular with the XL attach-
ment.
4.4.11 Stabilising rollers with bracket ASR 25
For parking and manually moving the empty machine.
The stabilising rollers consist of two turning wheels in front and two non-turning
wheels at the rear without wheel lock.
4.4.12 Boundary spreading unit GSE 30 (only for AXIS 20.2/30.2/40.2)
Limits the spreading width (either towards the left or right) to a range between ap-
prox. 0 m and 3 m from the centre of the tractor to the outer edge of the field. The
metering slide that points to the field edge is closed.

Fold the boundary spreading unit downwards for boundary spreading.

The boundary spreading unit must be folded up again before starting the two-
sided spreading.
4.4.13 Boundary spreading unit GSE 60 (only for AXIS 50.2)
Limits the spreading width (either towards the left or right) to a range between ap-
prox. 0 m and 3 m from the centre of the tractor to the outer edge of the field. The
metering slide that points to the field edge is closed.

Fold the boundary spreading unit downwards for boundary spreading.

The boundary spreading unit must be folded up again before starting the two-
sided spreading.
4.4.14 Hydraulic remote control FHD 30-60 for GSE 30 and GSE60
This remote control is used from the tractor cabin to hydraulically swing the
boundary spreading unit into position or to swing it from boundary spreading po-
sition into the two-sided spreading position.
For operating the hydraulic remote control FHD 30-60, a double-acting control
valve is required.
NOTICE
The steps must never be used during the spreading operation!

Before starting the spreading operation, the steps are to be folded in at all
times.