Maintenance and repair
9
118
5.
Check the O-rings for damage and replace as necessary.
6.
Tighten the filter housing [3] with the SW24 spanner up to the limit stop and
screw it back by a quarter turn.
7.
Vent the hydraulic pressure filter.
The filter cartridge has now been replaced successfully.
Check all components for external damage and leaks.
9.13
Transmission oil
The transmissions (left/right) of the machine are filled with approx.
0.3 l
of trans-
mission oil.
9.13.1 Checking the oil level
Requirements:
The mineral fertiliser spreader is in a horizontal position.
Switch off the tractor engine and the ISOBUS machine control unit. Remove
the ignition key of the tractor.
Figure 9.21:
Gear oil filling and draining points
[1] Protective cover
[2] Protective cover mounting screws
[3] Drain screw
Disassemble the protective cover.
Untighten the drain screw.
The oil level is satisfactory when the oil reaches the lower edge of the hole.
Reassemble the protective cover.
NOTICE
Only use one type of oil.
Never
mix different oil types.
1
2
3
Содержание AXIS H EMC Series
