Rauch AXEO 16.1, Инструкция по эксплуатации

Страница: 105 / 136

Maintenance and service
97
9
9 Maintenance and service
9.1 Safety
Maintenance and service involve additional hazards that do not occur during op-
eration of the machine.
Any maintenance and service work is to be conducted with increased alertness
at all times. Work very carefully and with awareness of danger.
Observe the following instructions in particular:

Welding and work on the electrical and hydraulic systems is to be carried out
by qualified technicians only.

There is a risk of tipping when working at the lifted machine. Secure the ma-
chine using suitable supports.

There is a risk of crushing and shearing at automatically operated compo-
nents (adjustment lever, metering slide).Make sure that there is no one in
close proximity to the moving parts during maintenance.

Spare parts must at least comply with the technical requirements specified by
the manufacturer. This is assured by using RAUCH original spare parts.

Before starting any cleaning, maintenance, or repair work, and when trouble-
shooting, switch off the tractor's engine and wait until all rotating parts of the
machine have come to a stop.

Repairs may only be carried out by instructed and authorised specialists.
9.2 Wear parts and screw connections
9.2.1 Checking wear parts
Wear parts include: Spreading vane , Agitator , Hopper base and thrust ring .

Checking wear parts.
If these parts show visible signs of wear, deformation or holes, any worn parts
must be replaced; otherwise the spreading pattern will not be correct.
The durability of wear-prone parts depends in part on the spreading material used.
NOTICE
Arrange for your dealer to carry out major servicing work.
NOTICE
Please also refer to the warning notes in chapter 3: Safety, page 5 . Take par-
ticular note of the instructions in section 3.8: Maintenance and service, page 13 .