Rato RG3.6-75Q-D-II, Руководство пользователя

Страница: 23 / 32

8.7 OIL CHANGE
Drain the engine oil when the engine is warm. Warm oil drains quickly and
completely.
8.7.1 Turn the fuel valve to
off
position to reduce the possibility of fuel.
8.7.2 Place a suitable container next to the engine to catch the used oil.
8.7.3 Remove the drain bolt and drain the oil into the container by slightly tipping
the engine toward the oil filler cap/dipstick.
8.7.4 With the engine in a level position, fill to the upper limit mark on the dipstick
with the recommended oil(Oil grade: SAE 15W-40).
Engine oil capacity: 0.6L
Gear box oil capacity: 0.75L
ƽ Running the engine with a low oil level can cause engine damage.
ƽ Engine oil is poisonous, be careful not to touch it.
8.7.5 Reinstall the oil filler cap/dipstick securely.
We suggest you take used oil in a sealed container to your local recycling center or
service station for reclamation. Do not throw it in the trash, pour it on the ground,
or down a drain.
8.8 LUBRICATION
No service must be carried out before:
The engine has stopped.
The cable has been disconnected from the spark plug.
Lubricate the linkage every 10 hours of use and before long time storage. Use 10W
oil.
No parts inside the gearbox are to be lubricated. All bearings and bushings are
permanently lubricated and require no maintenance.
Lubricating these parts will only result in the grease getting on to the friction wheel
and disc drive plate, which could damage the rubber clad friction wheel.
For long time storage the above-mentioned parts should be lightly wiped with an
oily rag to prevent rust.
8.9 AIR CLEANER SERVICE
A dirty air filter will restrict air flow to the carburetor, reducing engine
performance. If you operate the engine in very dusty areas, clean the air filter more
often than specified in the
MAINTENANCE SCHEDULE .
NOTICE
Operating the engine without an air filter, or with a damaged air filter, will allow
dirt to enter the engine, causing rapid engine wear.
8.9.1 INSPECTION
20