Ratmon RAT-2, Руководство пользователя

Страница: 16 / 16

16
3. Manual checking of GSM signal strength
In order to check current GSM signal strength, press once button „Setup” until LED starts flashing
purple and next press button „Start”.
The level of GSM signal strength will be presented on LEDs CH1 to CH4 in purple.
4. Manual triggering of resistance measurement
Press button „Setup” until LED flashes in dark blue. Next press button „Start”. LEDs CH1 to CH4
will inform which channels are ready for measurements. Following pressing of button “Start” triggers
measurement. If result is positive, LED CH X stops lighting. If result exceeds set warning or alarm
limit, LED of CH X will light yellow or red, respectively.
5. Manual triggering of TDR measurement (RATCombo)
Press button „Setup” until LED flashes light blue. Next press button „Start” . LEDs of CH 1 to CH
2will inform which channel is ready for measurements. By pressing button „Setup” you can change
channel. Following pressing of button „Start” triggers measurement.
6. Remote update of the device
When the update process starts communication LED light in white and update progress is
presented on LEDs CH1 to CH2 in green.
Used electrical and electronic equipment should be collected selectively, i.e. it must not be placed
with other types of waste.
Worn-out electronic equipment should be taken to a collection point in accordance with the Waste
Electrical and Electronic Equipment Act.
Before handing over the equipment to a collection point, do not disassemble any parts from this
equipment yourself.
Observe local regulations regarding disposal of packaging, waste batteries and accumulators.
DISPOSAL