ratiotec RT 650, Руководство пользователя

Страница: 7 / 16

7
[EN]
Pin Code adjustment
1. Operator code (4-digit)
The initial operator code is 1111. To change the operator, type (when the
door is opened) a new 4-digit code and confirm it by pressing the #-key
(e.g. 2222#). The new code will be activated after closing the door.
2. Supervisor code (6-digit)
The initial supervisor code is 123456. To change the supervisor code,
press # (red light on) and dial valid supervisor code, end with #. Dial the
new code again and end with # (red light off and you hear a long beep).
3. Master code (8-digit)
This code should only be used in case the operator and supervisor codes
are unknown because after typing the master code, the operator and
supervi sor code will reset to factory setting (1111 resp. 123456). Dial the master code (which is written by hand
on the first page of the manual), end with #. There is no time delay when you dial the master code.
Please note: If you dial the wrong code 3 times the safe will be locked for 5 minutes.
Open with a time interval
The safe cannot be opened immediately. To open the safe dial the valid opening code and press the #-key to
activate the countdown. The time delay is preset to 3 minutes, so during 3 minutes delay period a green light
will flash (every 2-3 seconds) and then red light will flash twice and a longer signal tone will arise after the time
delay period is over.
Dial the valid opening code and # again within 30 seconds. In case an incorrect code has been entered or you
do not dial the code within 30 seconds the lock goes back to standby mode and you have to start again to open
it.
Please note: The safe can be directly opened, even without having acti vated the countdown, by typing the
master code and confirming it with the #-key.