Ratio io7, Руководство по установке, Страница: 18 / 34

Installation | 17
+44 (0) 1527 396900 / info@ratioev.uk / www.ratioev.uk
The installer must follow the next steps to prepare the io7 to be connected to the
preferred communication method and third party back-end software.
The main sequence of steps are as follows:
1. The charger should be powered up. The LEDs will illuminate white whilst the charger is
booting up. Once ready, the charger LEDs will turn green. At this point the user interface
can be accessed. This will enable the charger’s Wi-Fi Hotspot for 10 mins. If the log in
process is not completed within this time frame, the charger must be rebooted.
2. Using a mobile device or laptop, search for the chargers Wi-Fi Hotspot as illustrated
below.
7. Close the door and secure using the HM5 Pin Hex Allen Key. Ensure Earth cable is
connected, remains intact and is not trapped when the door is repositioned and closed.
6. Commissioning the io7
SHEET SIZE SHEET No REVISION DRAWING No
1 A1 1 of
FIRST ANGLE
SCALE - SEE DRAWING VIEWS DO NOT SCALE
UNITS - mm
CHECKED
DESCRIPTION
DRAWING No REVISION REVISED BY REVISION DATE
PROJECT No CREATION DATE DRAWN BY
The contents of this document belong to FW Thorpe PLC. Reproduction in whole
or part of the article shown may only be made with prior written permission.
MATERIAL
LATEST REVISION DETAILS
FINISH
A division of FW Thorpe Plc
C
15/12/2022 tom.jennings
GENERAL TOLERANCE LIN mm ANG deg
PRODUCT RANGE :
6.1. Initial Steps